Seat ATECA 2024 - Cornering Light Function; Motorway Light

Lights
101
Vehicle lighting
The automatic dipped beam is only an auxili-
ary function and cannot always identify all sit-
uations that may arise during driving with su-
cient precision.
Cornering light function
The cornering light is an additional function to
the dipped beam to improve lighting of the side
of the road when cornering at low speeds.
When the dipped beam is on, a static cornering
light comes on when driving at speeds below
about 40km/h (25mph) or on very tight bends.
●
If the steering wheel is turned or the turn sig-
nal is switched on, the front fog light gradually
turns on. Once the turn has been made, the
cornering light progressively turns o.
●
When engaging reverse gear, both front fog
lights turn on.
Daytime running lights
Daytime running lights can increase vehicle vis-
ibility when driving during the day.
The daytime running lights switch on every time
the ignition is switched on, if the switch is in
positions or , according to the level of
exterior lighting.
Motorway light
The function is switched on and o via the cor-
responding Infotainment system menu.
●
Activation: when going above 110km/h
(68mph) for more than 10 seconds, the dipped
beam raises slightly to increase the driver's visi-
bility distance.
●
Deactivation: when the speed of the vehicle
is reduced below 100km/h (62mph), the dip-
ped beam immediately returns to its normal po-
sition.
Warning buzzers to warn that the lights have
not been switched o
If the ignition is not connected and the driver's
door is open, an audible warning signal is heard
in the following cases: this will remind you to
turn the light o.
●
When the parking light is on ›››page102.
●
When the light switch is in position or .
If the exit lighting is switched on (“Coming
Home” function), when you leave the vehicle
there will be no audio warning to warn you that
the lights are still on.
WARNING
Accidents can occur if the road is not well lit
and other road users cannot see the vehicle
or see it with diculty.
●
The automatic dipped beam control ( )
only switches on the dipped beam when
there are no changes in brightness, and not,
for example when it is foggy.
WARNING
The side light or daytime running light does
not provide sucient illumination to see the
road properly or to be seen by drivers of
other vehicles.
●
Always switch on the dipped beam head-
light at night, in rainy weather or when visibil-
ity is poor.
●
Daytime running lights must never be used
when the road is poorly lit due to weather or
lighting conditions.
●
On vehicles with tail lights with bulbs,
switching on the daytime running lights does
not switch on the tail lights. A vehicle without
tail lights may not be seen by other drivers
in the dark, in case of rain or unfavourable
visibility conditions.
WARNING
Other road users may be distracted and daz-
zled if the headlights are set too high and
used inappropriately. This could cause an
accident, with serious consequences.
●
Always make sure that the headlights are
correctly adjusted .