Seat ATECA 2024 - Main Beam Assist (Light Assist)

Lights
103
Vehicle lighting
Parking light on both sides
●
Switch the ignition o.
●
Place the light switch in position .
●
Lock the vehicle from the outside.
When this is done, only the side lights of both
headlights, along with the tail lights, partially
light up.
WARNING
Using turn signals inappropriately, not using
them or forgetting to turn them o can con-
fuse other road users. This could cause an
accident with serious consequences.
●
Always give warning of lane changes, over-
taking or turning manoeuvres by activating
the turn signals well in advance.
●
As soon as the lane change, overtaking or
turning manoeuvre is complete, switch o
the turn signal.
WARNING
Improper use of the main beam can cause
accidents and serious injuries, as it can dis-
tract and dazzle other drivers.
Note
●
When you turn the ignition o without hav-
ing turned the turn signals o, an audible sig-
nal sounds while the driver door is open. It
is intended to remind you to turn o the turn
signals, unless you want to leave the parking
light on.
●
If the convenience turn signals are on
(three flashes) and the convenience turn sig-
nal on the opposite side is activated, the ac-
tive side stops flashing and only flashes once
on the newly selected side.
●
The turn signal only works when the igni-
tion is switched on. The turn signals only
work when the ignition is switched on.
●
The main beam can only be switched on
when the dipped beam is switched on.
●
If a trailer turn signal fails, the indicator
light (trailer turn signals) stops flashing, in-
stead of flashing the turn signal at double
speed in the vehicle.
●
In cold or wet weather conditions, the
headlights, tail lights and turn signals may
be temporarily fogged from the inside. This is
normal and has no eect on the service life
of the vehicle's lighting system.
●
The parking light does not activate auto-
matically if the left- or right-hand turn signal
is left on and the ignition is disconnected.
Main beam assist (Light Assist)
The main beam assist automatically prevents
glare from aecting vehicles moving in the op-
posite direction or ahead in the same direction.
In addition, the main beam assist detects illumi-
nated areas and disconnects the main beam
headlight when passing populated areas.
Within its limitations, the assist system automat-
ically connects or disconnects the main beam
headlight depending on the environmental and
trac conditions, as well as the speed ›››
.
Switching on the main beam assist
●
Turn on the ignition and turn the light switch to
position .
●
From the neutral position, press the turn sig-
nal and main beam headlights lever forwards
›››Fig.81
3
.
When the main beam assist is switched on, the
control lamp on the instrument cluster dis-
play turns on. When the main beam is on, the
blue main beam control lamp on the instru-
ment cluster switches on.
Switching the main beam assist o
●
Turn the headlight switch to a position other
than .
●
EITHER: if main beam assist is on, pull the turn
signal light and main beam headlights lever
back ›››Fig.81
4
.