Seat ATECA 2024 - Page 168

166
Assistant systems
Lights up green
ACC connected, no vehicle detected in
front.
Lights up green
ACC connected, vehicle detected in
front.
When the ACC is in standby, the indicator
lamps light up grey.
Program the speed
To program the speed, press the or
›››Fig.115 buttons to the desired speed. The
speed is adjusted at intervals of 10 km/h (5
mph).
While the ACC is active, you can press the
button to increase the desired speed by 1 km/h
(1 mph). You can then press to decrease it
by 1 km/h (1 mph).
Program the distance setting
The distance can be set to one of five levels,
from very short to very long:
●
Press the button and then or button
›››Fig.115.
●
Alternatively, press button as many times
as necessary to set the desired distance.
Keep in mind each country’s regulations on
minimum braking distances.
Suspend regulation (standby)
●
Briefly press button ›››Fig.115 or press the
brake pedal.
The ACC indicator lamp is grey; the speed and
distance are saved.
If the ESC or TCS is switched o, the ACC is
automatically interrupted.
Reinstating the cruise control
●
Press the button. The ACC regulates to
the last speed and distance setting.
●
OR: Press button to regulate to the current
speed.
Switching o
●
Press and hold the button . The set speed is
cleared.
Exceeding the speed regulated by the ACC
While driving with the ACC switched on, the
driver can increase speed by pressing the ac-
celerator pedal. ACC regulation is suspended
until you release the accelerator pedal ››› .
Changing the driving profile
In vehicles with the SEAT Drive Profile, the se-
lected driving profile can have an influence on
the ACC’s acceleration and braking behaviour
›››page149.
In vehicles without SEAT Drive
Profile, the be-
haviour of the ACC can also be aected if any
of the following drive profiles are selected in
the infotainment system in Drive assist. ACC
settings will be the same as those in the SEAT
Drive Profile.
WARNING
Before driving o, check that the road is
clear. The radar sensor may not detect ob-
stacles that could be on the road. This can
lead to an accident and serious injury. Press
the brake if necessary.
NOTICE
If you increase speed using the accelerator
pedal, the ACC may not be able to safely
adjust the speed of the distance due to the
limitations of the system.
●
Be prepared to react if required by the sit-
uation.