Seat ATECA 2024 - Emergency Assist

Assistant systems
179
Emergency Assist
Troubleshooting
Travel Assist is not available or does
not work as expected
The control lamp lights up in yellow. A relevant
warning is also displayed on the instrument
cluster display.
●
There is a fault in the sensors. Check the cau-
ses and solutions described in the information
about the ACC ›››page169 or the Lane Assist
›››page176.
●
There is a fault or a defect. Switch the engine
o and on again.
●
The system limits are exceeded.
●
If the problem persists, consult a specialised
workshop. SEAT recommends visiting a SEAT
dealership.
Grip the steering wheel
The warning lamp lights up white and a mes-
sage is then shown on the instrument cluster
display.
●
You released the steering wheel for a few sec-
onds. Take hold of the steering wheel and take
control of the vehicle.
Grip the steering wheel
The warning lamp lights up red and a mes-
sage is shown on the instrument cluster display.
Depending on the situation, an audio warning
sounds or the steering wheel vibrates.
●
You have let go of the steering wheel for
a long time, or the system limits have been
reached. Immediately take hold of the steering
wheel and take control of the vehicle.
Travel Assist disconnects automatically
●
There is a fault or a defect. Switch the engine
o and on again.
●
If the problem persists, consult a specialised
workshop. SEAT recommends visiting a SEAT
dealership.
Regulation is interrupted unexpectedly
●
You have turned on the turn signal.
Emergency Assist
How it works
Emergency Assist can detect whether the driver
is inactive and can automatically keep the car
in its lane and stop it altogether if necessary.
This way the system can actively help avoid an
accident or reduce its consequences.
Emergency Assist uses the same sensors as
Adaptive Cruise Control (ACC) and Lane As-
sist Therefore, carefully read the information
about the ACC ›››page164 and Lane Assist
›››page174 and take into account the limita-
tions of the systems and the indications given in
the information.
Emergency assist always available after the ig-
nition has been switched on and is activated if
the following conditions are met:
●
Travel Assist or Lane Assist) is switched on.
●
The system has detected at least one lane
boundary to the left or right of the vehicle.
Driver intervention prompt
If the emergency assist detects that the driver is
not actively doing anything, he or she is promp-
ted to take control of the vehicle by audio
warnings and a brief application of the brake. In
addition, a warning is shown on the instrument
cluster display and the volume of the infotain-
ment system is lowered.
Depending on the equipment, the driver’s seat
belt is tightened at the same time.
System intervention
If the driver does not react, the system can
brake the vehicle and keep it in its lane. The fol-
lowing control lamp lights up on the instrument
cluster display:
The system is regulating, lane guidance
is activated.
The system is regulating, passive lane
guidance.