Seat ATECA 2024 - Automatic Activation

Parking and manoeuvring
207
Peripheral view system (Top View Camera)
Automatic activation
●
Select reverse gear.
●
EITHER: the vehicle moves backwards.
The view of the image of the vehicle's rear cam-
era is shown in parallel parking mode with the
reduced top view.
Manual disconnection
●
Press the ›››Fig.147 button again.
●
EITHER: press a button on the infotainment
system, for example the button.
●
OR: press the function button.
Automatic disconnection
●
Drive forward at a speed of at least 15 km/h
(9 mph).
●
OR: switch o the ignition. The Area View
system menu disappears immediately.
Views of the peripheral vision system
(modes)
Fig.148 Display on the Area View system
screen: Front camera: o-road view. Rear
camera: o-road view.
The red lines indicate a distance of approx. 40
cm away from the vehicle.
Top views (bird's eye view)
Main mode:
The vehicle and its immediate vicinity
seen from above are shown. Depending
on the equipment, the ParkPilot's path
may also be displayed.
Three-dimensional views:
The vehicle and its vicinity seen from above
are shown.
The vehicle and its vicinity seen from
above are shown obliquely.
The vehicle and its vicinity seen obli-
quely are shown.
Swipe the infotainment system display with
your finger in the direction of the arrows to
change the angle of vision in the three-dimen-
sional views of the vehicle and its vicinity.
Front camera views (front view)
Cross trac.
This visualization helps to monitor trac
to the left, front and right of the vehicle
and can be used, for example, when exit-
ing garages or narrow exits
Angle parking.
The area in front of the vehicle is shown.
Orientation lines are shown to give guid-
ance.
O-road.
The area directly in front of the vehicle
seen from above is shown. For example, on
a slope, in order to see the area directly in
front of the vehicle.