No. Consumer/Amps
18
Terminal 30 (positive refer-
ence)
7.5
19 Front windscreen washer 30
21
Automatic gearbox control
unit
15/30
22 Engine control unit 7.5
23 Starter motor 30
24 PTC 40
36 Left LED headlight 15
37 Parking heating 20
38 Right LED headlight 15
Note
●
In the vehicle, there are more fuses than
those indicated in this chapter. These should
only be changed by a specialised workshop.
●
Positions not containing a fuse do not ap-
pear in the tables.
●
Some of the equipment listed in the tables
pertain only to certain versions of the model
or are optional extras.
●
Please note that the above lists, while cor-
rect at the time of printing, are subject to
change.
Changing bulbs
Introduction
Changing bulbs requires a certain degree of
practical skill. If you are unsure, SEAT recom-
mends that you consult a technical service or
request assistance from a specialist. In general
a specialist is needed if, in addition to the bulbs,
other vehicle components require removal.
Always use identical bulbs with the same desig-
nation. The name can be found on the base of
the bulb holder.
Depending on the vehicle’s equipment, there
are two tail light systems:
●
LED tail lights
●
Basic variant of tail lights with LEDs and bulbs.
LED technology lights
Full-LED headlights handle all light functions
(daylight, side light, turn signal, dipped beam
and full beam) with light emitting diodes (LEDs)
as a light source. They have been designed to
last the lifetime of the vehicle and the bulbs
cannot be replaced. In case of headlight fail-
ure, go to an authorised workshop to have it
replaced.
The fog lights, number plate light, side turn
signals and additional brake light are all LED
bulbs. With this in mind, they should be re-
placed by a technical service.
Bulbs (12 V)
Depending on the level of equipment fitted in
the vehicle, LEDs may be used for part or all of
the interior and/or exterior lighting. LEDs have
an estimated life that exceeds that of the vehi-
cle. If an LED light fails, go to an authorised
workshop for its replacement.
Light source used for each function
Basic variant of tail lights with
LEDs and bulbs
Type
Turn signal PY 21W LL
Reverse lights W16W
The remaining functions work with LEDs
WARNING
●
Bulbs are highly sensitive to pressure. The
glass can break when you touch the bulb,
causing injury.
●
When changing bulbs, please take care not
to injure yourself on sharp edges, in particu-
lar on the headlight housing.
To Next Page
Loading...
