Seat CUPRA LEON 2022 - Net Partition

Storing objects
279
Net partition
NOTICE
●
The maximum weight that can be loaded
on the luggage compartment variable oor in
the top position is 100 kg.
●
Do not let the luggage compartment oor
fall when closing it. Always carefully guide
it downwards in a controlled manner. Other-
wise, the lining and the oor of the luggage
compartment could be damaged.
Net partition
Partition net behind the rear seat
Valid for: Leon Sportstourer
Fig.181 In the boot: securing the partition
net.
Fig.182 In the boot: removing the
partition net.
Pulling out and securing the net partition
●
Pull up handle ›››Fig.181
2
to remove the
net from the casing
4
.
●
Hook in the net partition on the right or left
side
3
(magnied image).
●
Hook in the net partition into the housing on
the other side
1
by pulling the rod.
The net partition is properly assembled when
the T-shaped ends are rmly secured in the
corresponding housings
3
and
1
.
Retracting the net partition
●
Unhook the rod from the housings
3
and
1
.
●
Roll up the net into the casing
4
lowering it
with your hand.
Removing the net partition
●
Fold the rear seat backrests forward.
●
Press the left or right release catch
›››Fig.182 in the direction of the arrow
1
.
●
Remove the casing from the support in the
direction of the arrow ›››Fig.182
2
.
Fitting the net partition
●
Fold the rear seat backrests forward.
●
Fit the casing in the right and left supports.
●
Press the casing into the left and right sup-
ports in the opposite direction to the arrow
›››Fig.182
2
until it engages. The red mark-
ings on the release buttons should no longer
be visible.
WARNING
●
Always secure objects, even when the net
partition is properly assembled.
●
There should be nobody behind the as-
sembled partition when the vehicle is mov-
ing.
●
The attachments on the backs of the rear
seats must never be used to t the net par-
tition when the rear seat backs are in their
vertical position.