Seat Ibiza 2024 - Parking Manoeuvre; How It Works

170
Parking and manoeuvring
1)
The RVC button will only be displayed when reverse gear is engaged.
2)
It is only displayed if the vehicle is equipped with a parking system.
Switching the system on and o
●
Reverse assist is connected by a contact
when engaging r
everse gear.
●
The system switches o 8 seconds after dis-
engaging reverse gear and immediately after
removing the contact.
●
The camera will stop transmitting images
above the speed of 15 km/h (9 mph) with re-
verse engaged.
In combination with the parking aid plus system
›››page164, the camera image will no longer
be displayed when reverse gear is disengaged,
and the system will display the optical informa-
tion provided by the parking aid system.
It is also possible to hide the reverse assist im-
age:
●
By pressing one of the Infotainment system
buttons on the display.
●
OR: by pressing on the miniature vehicle
shown on the screen.
If you wish to display the rear assist image
again:
●
Disengage and re-engage reverse gear.
●
OR: Pr
ess the RVC function button
1)
.
Parking manoeuvre
●
Stop the vehicle in front of a space and select
r
everse gear.
●
Reverse slowly, and turn the steering wheel
so that the side lines lead towards the parking
space.
●
Guide the vehicle into the parking space so
that the side lines run parallel to it.
Rear Cross Trac Alert)
How it works
Fig.126 Diagr
am of the parking assistant:
detected area around the vehicle that is driving
o.
Park Assist uses the radar sensors on the rear
bumper ›››page138 t
o monitor trac cross-
ing behind the vehicle as it reverses out of a
parking bay, or as it is being manoeuvred, for
example in very low visibility conditions.
When the system detects a relevant vehicle on
the road that is approaching the rear of the ve-
hicle ›››Fig.126, an acoustic alarm may sound
if the relevance so requires it.
In addition to the acoustic alarm, the driver is
also informed by means of a visual signal on
infotainment system display. This signal is dis-
played in the form of a red strip at the back
of the image of the vehicle on the infotainment
system screen. This strip displays the side of the
vehicle towards which trac is approaching in
transverse direction
2)
.
Automatic braking to reduce damages
›››page162.
Connecting and disconnecting
The rear cross trac alert can be switched on
and o by accessing the Assistants menu on
the dash panel display using the steering wheel
controls. If the vehicle is equipped with a multi-
function camera, it can also be accessed by
means of the assistants systems key located on
the main beam headlight lever.