Seat Ibiza 2024 - Changing Bulbs

Miscellaneous situations
253
Changing bulbs
Fuse arrangement in engine compartment
No. Consumer/Amps
1
MPI Engine Injection Module 10
TSI Engine Injection Module 15
2
Fuel metering valve (TJ4/T6P/
N09), L
ow temperature coolant
pump (TJ4/T6P/N09/TC5); Oil
pressure regulating valve (TJ1),
AGR coolant valve (TJ1), High and
low pressure water pumps (TJ1),
SCR relay coil, cylinder head wa-
ter valve
7.5
3 Lambda probes 15
4
Engine petrol pump relay (MPI),
Gauge control unit (TSI)
15
5
Electric fan (EC), LDR valve, can-
nister and variable distribution
valve, oil pressure regulating valve,
cylinder disconnection valves, WIV
sensor
10
6 Spark plugs (MPI and TSI) 20
7 Vacuum pump (TSI) 15
8 Injectors and EKP relay coil (MPI) 10
9 Servo sensor 7.5
10
Vref Battery: Gateway, BDM and
BCM
7.5
12 Detachable compressor 10
No. Consumer/Amps
14
ESC, Relay 87 coil and engine
controller of engines (+ TJ1 / TJ4 /
TH4 / T5I / T6P / N09 / TC5 / T5Y).
7.5
15
Automatic gearbox DQ200 and
AQ160
30
17 50 Diag 7.5
18 BDM starter motor 30
20
ESC (Pump) 60
ABS (Pump) 40
21 ESC/ABS (Valves) 25
24
TH4 Electric fan without A/C for
moderate climate countries
30
25
TH4 fan with A/C or T5I for moder-
ate climate countries
20
PTC1 40
26
TJ1/TJ4/N09/T6P or TH4/T5I Elec-
tric fan for warm climate countries
50
27
TH4 fan with A/C or T5I for moder-
ate climate countries
30
PTC2 40
28 PTC3 40
Note
●
In the vehicle, there are more fuses than
those indicat
ed in this chapter. These should
only be changed by a specialised workshop.
●
Positions not containing a fuse do not ap-
pear in the f
ollowing tables.
●
Some of the equipment listed in the tables
bel
ow pertain only to certain versions of the
model or are optional extras.
●
Please note that the above lists, while cor-
r
ect at the time of printing, are subject to
change.
Changing bulbs
Introduction
Changing bulbs requires a certain degree of
practical skill. If you are unsure, SEAT recom-
mends that you consult a technical service or
request assistance from a specialist. In general
a specialist is needed if, in addition to the bulbs,
other vehicle components require removal.
Always use identical bulbs with the same desig-
nation. The name can be found on the base of
the bulb holder.
Depending on how equipped the vehicle is,
there are dierent sets of headlights and tail
lights:
●
ECOLED (full-LED) main headlights
●
High (full-LED) main headlights