TIPS AND MAINTENANCE
IF AND WHEN ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
3.53
Tool housing
Van
– behind the driver’s seat and
– to the interior of the spare wheel
Kombi
– in the rear part of the luggage area,
housed in the cover of the right side
panel and
– to the interior of the spare wheel.
Spare wheel housing
The spare wheel is fitted under the vehi-
cle, at the back, secured by a special
drop-down bracket (wheel carrier).
On-board tools
Warning
•
The jack supplied by the manu-
facturer is for this model only.
Never use it for other heavier vehi-
cles or for other loads.
•
Never start the engine when the
car is raised. Danger of accidents.
•
If work must be done beneath
the vehicle, it must be supported
with appropriate axle stands.
Vehicle tools in the spare wheel
recess
– Tool box
– Jack
Before the jack is placed back into the
tool box, the claw must be fully wound
back. The crank is then tensioned against
the side of the jack.
On board tools, spare wheel
IN0-045A
To Next Page
Loading...
