Changing the fuses
•
Switch off the circuit concerned.
•
Using the fuse table, determine which
fuse belongs to the circuit point con-
cerned.
•
Remove the respective fuse.
•
Replace the blown fuse (which may be
recognized by the break in the metal strip)
with a new fuse of the same Ampere rat-
ing.
Remarks
•
If the fuse burns out again shortly after
being changed, immediately take your
vehicle to a Technical Service Centre to
have the installation checked.
•
Under no circumstances should
“repaired” fuses be used, since they
could cause damage of greater
importance in other parts of the elec-
trical installation.
•
Some of the circuits listed in the table
belong only to certain versions of the
model or are optional equipment.
3.68
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– IF AND WHEN
TIPS AND MAINTENANCE
IN0-056
To Next Page
Loading...
