Unless otherwise indicated, all tech-
nical details provided below apply to
vehicles with standard fittings.
These values may be different for spe-
cial vehicles or vehicles destined for
other countries.
Please bear in mind that the data in
the car’s official documents takes
precedence.
Engine data
The engine fitted in your vehicle is
indicated in the data sheet included
in the Inspection and Maintenance
Plan and in the car’s official docu-
ments.
Performance
These values were calculated without
extra equipment reducing performance,
such as air conditioning, mud flaps, extra
wide tyres, etc.
Fuel Consumption
The consumption and emission levels
were calculated using the 93/116/CE
measuring standards and take into
account the true free-standing weight of
the vehicle (weight category). To measure
the fuel consumption the vehicle is tested
in two different cycles on a rolling bench
under the following conditions:
•
Town driving
is measured from a cold
start of the engine. Then, driving condi-
tions similar to those of in-town driving
are simulated.
•
Intercity driving
the car is accelerated
and braked in all gears, just as in normal
driving. The driving speed varies between
0 and 120 km/h.
•
Total consumption
is based on a bal-
anced average of 37% of town driving and
63% of intercity driving.
•
CO
2
emission levels
are obtained
from the exhaust fumes of the vehicles
tested in town and intercity driving on a
rolling belt. These fumes are then ana-
lysed and the CO
2
emission levels are
obtained, among other values.
Notes
•
The consumption and emission levels
are correct for unloaded vehicles with
basic fittings. If there are extra fittings,
the empty weight will increase and, as a
result, the weight category, which may
slightly increase the consumption and
CO
2
levels. Contact your SEAT Official
Service Centre to find out the exact speci-
fications of your vehicle.
•
Driving style, road and traffic condi-
tions, weather conditions and the condi-
tion of the vehicle will, in practice, pro-
duce consumption levels different to
those indicated.
Weights
Note
These weights are valid for European
Union vehicles. Vehicles for other coun-
tries may have other weights. At all times
it should be taken into account that the
data given with the official vehicle docu-
ment prevails.
4.2 ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
GENERAL NOTES
TECHNICAL DATA
General considerations on technical data
To Next Page
Loading...
