Seat Inca 2020 - Indicators and dipped beam lever

LIGHTS AND VISIBILITY ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– 2.31
HANDLING INSTRUCTIONS
Indicators and dipped beam lever
The indicator lights work only with the
ignition on.
Right indicators – lever up
Left indicators – lever down
The control light blinks at the same time
as the indicators are working. See the
"Warning lamps" chapter.
When the steering wheel is straightened
again the indicators switch off automa-
tically.
When changing lanes
Raise or lower the lever only to the pres-
sure point and hold in this position; the
control light must go on at the same time.
High beams, low beams
With the low or high beams on, pull lever
towards the steering wheel, beyond the
perceptible pressure point. With the high
beams on the warning lights will go on at
the same time.
Headlight flasher
Pull lever towards the steering wheel to
the pressure point the high beam warning
light will go on.
Note
The use of the vehicle lights is subject to
local regulations.
Light alarm*
When leaving the vehicle, if the light
switch is on, an alarm will sound when
doors are opened.
IN0-016