Reverse gear acoustic
Manual gearbox warning*
•
Only engage reverse gear when vehicle
is stationary. When engine is running,
depress clutch fully and wait a few sec-
onds before moving gear lever, to prevent
grating noises.
When reverse gear is engaged with igni-
tion on, the reversing lights come on.
Note
When driving you should not rest your
hand on the gear lever. The pressure
of your hand is transmitted to the
selector forks in the gearbox and can
cause premature wear on the forks.
Acoustic warning*
It works with the ignition on.
When you shift into reverse gear a buzzer
will sound as long as you remain in
reverse. This device can be switched on or
off by using the light switch.
Switching the acoustic warning
on/off
1. With the lights off:
Switch on the lights for approximately
0.1 sec. to 1 sec. and go back to the off
position (the warning will be switched
off).
2. With the lights on (position/dip/
flood):
Switch the lights off for approximately
0.1 sec. to 1 sec. (the warning will also
be switched off). To switch on the warn-
ing again, proceed in the same way.
HANDLING INSTRUCTIONS
IN0-033
2.58
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– DRIVING
To Next Page
Loading...
