If and when224
Inflating the tyre
– Remove the air compressor and hose from the container.
– Screw the retaining nut onto the valve.
– Plug the compressor cable into a 12 volt socket.
– Turn on compressor and monitor the pressure shown on the pres-
sure gauge.
Completing the repair
– Remove the compressor hose from the valve.
–Fit the valve cap.
– Unplug the compressor from the socket.
– Return all tools to their proper storing location.
Note
The compressor should never be allowed to run for longer than 6 minutes.
Fuses
Changing a fuse
If a fuse has blown it must be replaced.
Fig. 153 Left side of dash
panel: Fuse box cover
Fig. 154 Fuse box cover
in engine compartment
s1cg.2.book Seite 224 Montag, 25. April 2005 3:54 15
To Next Page
Loading...
