Seat Leon 2013 - Removing and Installing Subframe Without Steering Rack

8 - Left support
9 - Bolt
❑ Always renew after removing
❑ M8: 20 Nm +90°
❑ M10: 50 Nm +90°
10 - Bolt
❑ Always renew after removing
❑ 70 Nm +180°
11 - Right support
12 - Lower bonded rubber bush for pendulum support
❑ Renew ⇒ page 35
13 - Upper bonder rubber bush for pendulum support
❑ Renew ⇒ page 35
14 - Nut
❑ When tightening, counterhold multi-point socket of joint pin
❑ Always renew after removing
❑ 65 Nm
2.2 Removing and installing subframe with‐
out steering rack
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
♦ Engine and gearbox jack - VAS 6931-
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
2. Subframe 19