• Wheel bearing -1- must always be pointing upwards.
• Always put down the wheel bearing unit with the wheel hub
-2- facing downwards.
• Do not touch the inside of the wheel bearing when you pick it
up.
• Always take hold of the outside of the wheel bearing.
The same procedure applies to the wheel bearing without wheel
hub.
Installing
Installation is carried out in reverse order, noting the following:
• The threaded connections of the wheel bearing housing may
only be loosened and tightened in the unladen weight position
⇒ page 8 .
Specified torques
♦ ⇒ “7.1.3 Assembly overview - suspension, multi-link suspen‐
sion, four-wheel drive”, page 226
♦ ⇒ “8.4 Loosening and tightening threaded connections of drive
shaft”, page 266
♦ Bolts for heat shield, brake caliper and brake disc ⇒ Brake
system; Rep. gr. 46 ; Rear brakes; Assembly overview - rear
brakes
– When does wheel alignment have to be checked
⇒ page 302 ?
7.5 Renewing bonded rubber bush for wheel bearing housing
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
7. Wheel bearing, trailing arm 245
To Next Page
Loading...
