– Loosen nut -1-.
– Turn eccentric bolt -2- until specification is attained.
Note
The maximum adjustment range is 90° to the left or right of the
centre position.
– Tighten nut -1-.
– Check toe setting once again after tightening nut -A-
⇒ “1.4 Specified values for wheel alignment”, page 294 .
Specified torques
♦ ⇒ “5.1 Assembly overview - transverse links”, page 195 .
1.11 Adjusting front axle convergence
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
♦ Insert tool - V.A.G 1332/9-
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
308 Rep. gr.44 - Wheels, tyres, vehicle geometry
To Next Page
Loading...
