Seat Leon 2013 - Dustguard: Disassembly and Assembly

– Tighten nuts -arrows-.
Note
Ensure that boot is not damaged or twisted.
– Install lower noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
Note
Ensure that boot is not damaged or twisted.
– Bolt universal joint to steering box.
– Connect vehicle battery ⇒ Electrical system; Rep. gr. 27 ;
Battery; Disconnecting and connecting battery .
– Carry out basic setting for steering angle sender - G85- using
⇒ Vehicle diagnostic tester.
If new steering box has been installed, adapt electromechanical
power-assisted steering using ⇒ Vehicle diagnostic tester.
Specified torques
♦ ⇒ “4.1 Assembly overview - lower suspension link, swivel
joint”, page 68
♦ ⇒ “2.1 Assembly overview - subframe”, page 18
♦ ⇒ “3.1 Assembly overview - steering box”, page 358
♦ ⇒ “3.6 Repairing steering box”, page 385
♦ Bolts for pendulum support ⇒ Rep. gr. 10 ; Assembly mount‐
ings; Assembly overview - assembly mountings
♦ Exhaust system to subframe ⇒ Rep. gr. 26 ; Exhaust pipes/
silencers; Assembly overview - silencer .
♦ Bolts for noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
If even when using locating pins - T10486/1- a crooked steering
wheel is determined during the road test, carry out a wheel align‐
ment check. In this case the wheel alignment test results must be
archived in the vehicle files.
3.3 Dustguard: disassembly and assembly
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
378 Rep. gr.48 - Steering