– Tighten nuts -arrows-.
Note
♦
The lever of the vehicle level sender must point towards the
outside of the vehicle.
♦
Thread of vehicle level sender must be screwed into outer hole
in suspension link. Retaining lug for vehicle level sender must
engage in inner hole in order to guarantee correct installation
position.
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
Specified torques
♦ ⇒ “5.1 Assembly overview - wheel bearing”, page 87
♦ ⇒ “4.1 Assembly overview - lower suspension link, swivel
joint”, page 68
♦ ⇒ “3.1 Assembly overview - suspension strut, upper suspen‐
sion link”, page 56
♦ ⇒ “6.2 Assembly overview - drive shaft”, page 98
♦ ⇒ “2.1 Assembly overview - front vehicle level sender”,
page 281
♦ Screw for speed sender ⇒ Brake system; Rep. gr. 45 ; Sen‐
sors; Assembly overview - Front axle speed sender
♦ Bolts for splash plate, brake caliper, brake disc ⇒ Brake sys‐
tem; Rep. gr. 46 ; Front brakes; Assembly overview - front
brakes
5.3 Removing and installing wheel bearing
unit
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
Removing
– Remove bolt for drive shaft ⇒ page 120 .
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
5. Wheel bearing 93
To Next Page
Loading...
