Self-help
Check after 10 minutes of driving
Screw the inflator tube
›››
Fig. 33
5
again
and check the pressure on the gauge
6
.
1.3 bar (19 psi / 130 kPa) and lo
wer:
●
Stop the vehicle! The tyre cannot be
sealed sufficiently with the tyre mobility set.
●
You should obtain professional assistance
›››
.
1.4 bar (20 psi / 140 kPa) and higher:
●
Set the tyr
e pressure to the correct value
again.
●
Carefully resume your journey until you
reach the nearest specialised w
orkshop with-
out exceeding 80 km/h (50 mph).
●
Have the damaged tyre replaced.
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious in-
jury.
●
Do not continue driving if the tyre pres-
sure is 1.3 bar (19 psi / 130 kPa) and l
ower.
●
Seek specialist assistance.
Changing a wheel
R
el
at
ed video
Fig. 34 Wheels
What to do first
●
Park the vehicle on a horizontal surface and
in a saf
e pl
ace as f
ar away from traffic as
possible.
●
Apply the electronic parking brake.
●
Switch on the hazard warning lights.
●
Manual transmission: select the 1st gear.
●
Automatic transmission: Move the selector
lever to position P.
●
If you are towing a trailer, unhitch it from
your vehicle.
●
Have the vehicle tool kit
›››
page 38 and
the spare wheel* ready
›››
page 355.
●
Observe the applicable legislation for each
country (reflective vest, warning triangles,
etc.).
●
All occupants should leave the vehicle and
wait in a safe place (for instance behind the
roadside crash barrier).
WARNING
●
Always observ
e the above steps and pro-
tect yourself and other road users.
●
If you change the wheel on a slope, block
the wheel on the opposite side of the car
with a stone or similar to prevent the vehi-
cle from moving.
Integral wheel trim
Fig. 35 Remove the wheel cover.
The wheel covers must be removed for ac-
cess t
o the wheel nuts.
R
emo
ving
●
Take the wheel brace and the wire hook
from the vehicle tool kit
›››
page 38.
»
41
To Next Page
Loading...
