EasyManua.ls Logo

Seat LEON 2024 - Page 117

Seat LEON 2024
422 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Opening and closing
115
Window controls
Comfort opening and closing
The windows can be opened and closed from
the outside using the vehicle key:
Convenience opening:
Press and hold the button on the remote
control key until all the windows and the sun-
roof have reached the desired position.
OR: First unlock the vehicle using the button
on the remote control key and then keep the
key in the driver's door lock until all the windows
and the sunroof have reached the required po-
sition.
Convenience closing:
Press and hold button on the remote con-
trol key until all the windows and the sunroof
are closed ››› .
OR: Keep the key in the driver's door in the
"lock" position until all the windows and the
sunroof are closed.
OR: using the Keyless Access system (only
locking): Press and hold the locking sensor sur-
face ›››Fig.88 (arrow) on the door handle
for several seconds to close the windows and
the sunroof. If you stop touching the sensing
surface, the locking function is interrupted.
Comfort locking closes the windows first and
then the panoramic sunroof.
In the infotainment system dierent settings
can be adjusted using the function button
>
Vehicle > Exterior > Windows > Convenience
opening.
One-touch opening and closing
Automatic raising and lowering fully opens and
closes the windows. It is not necessary to press
and hold the appropriate window button for this
purpose.
For the automatic raising function: pull the but-
ton for the corresponding window upwards until
it reaches the second position.
For the automatic lowering function: push the
button for the corresponding window down-
wards until it reaches the second position.
Stop automatic movement: push or pull on the
button of the corresponding window.
Resetting the automatic raising/lowering
function
If the 12-volt battery is disconnected or dis-
charged when the windows are not completely
closed, the electric window automatic raising
and lowering function deactivates and has to
be reset:
Switch the ignition on.
Close all doors and windows.
Pull the corresponding window button up-
wards and hold it in this position for a few sec-
onds.
Release the button, pull it up again and hold it
in this position. This resets the automatic raising
and lowering function.
The function can be reset for a single window or
for several windows at the same time.
WARNING
Observe the safety warnings ››› in Intro-
duction on page108.
Improper use of the power windows can
cause injury.
Never close windows carelessly or in an
uncontrolled manner, as this could cause se-
rious injuries to you or third parties. There-
fore, make sure that no one is in the way of
the moving windows.
If the ignition is switched on, electrical
equipment such as the power windows could
activate, which can cause injury.
The vehicle doors can be locked with the
remote control key, making it dicult to get
help in an emergency.
Therefore always take the key with you
when you leave the vehicle.
The power windows are only deactivated
when the ignition is switched o and one of
the front doors is opened.
If necessary, deactivate the rear power
windows with the safety control. Make sure
that they have actually been deactivated.
For safety reasons, you should only unlock
and lock the vehicle with the remote control
key when you are approximately 2 metres
away from the vehicle. When pressing the
lock button, always monitor the movement
of the windows to avoid accidents. Releasing
the button immediately interrupts the closing
process.

Table of Contents

Related product manuals