Seat LEON 2024 - Page 218

216
Assistant systems
3
Green track on the overtaking lane: lane
change is in progress.
Activating and deactivating lane change as-
sist
You can activate and deactivate lane change
assist in the Infotainment system.
1. Access the assistant menu.
2. Select Travel Assist.
3. Activate or deactivate lane change assist
as a sub-function of Travel Assist.
Note
If a fault occurs in the system, the lane
change assist may automatically switch o
or be interrupted during the lane change.
Activating lane change assist while driving
Once the prerequisites have been met and the
programmed speed has been set with the
button:
1. Press the button again.
This activates the lane assist. The arrows
of your own lane on the instrument cluster
display are grey ›››Fig.146
2
Changing lanes
If the system detects no objects in the detec-
tion field of the sensor system and an assisted
lane change to an adjacent lane is possible, the
corresponding lane is shown in the instrument
cluster display next to the driver’s own lane. The
arrow on the corresponding side of the lane is
displayed in white ›››Fig.146
2
.
1. When the convenience turn signal is activa-
ted on the desired side, the vehicle changes
lane. A message is also displayed.
When changing lanes, the vehicle automati-
cally activates the turn signal on the corre-
sponding side. Once the lane change is com-
plete, the turn signal automatically switches o.
WARNING
The sensor system cannot reliably detect
all objects in the surroundings and operates
exclusively within the limits of the system.
If you use the lane change assist irresponsi-
bly, accidents and serious injuries can occur.
The system is not a replacement for driver
awareness.
●
Before changing lanes, make sure it is safe
to do so. In particular, rapidly approaching
objects may not be detected in time.
●
Keep your hands on the steering wheel at
all times and be prepared to control your
own speed and direction of travel.
Turning o the lane change assist
●
It turns o if the steering wheel is turned
sharply.
●
OR: by pressing the button.
●
OR: by pressing the brake pedal.
Lane change assist is deactivated.
Troubleshooting
Travel Assist is not available or does
not work as expected
The control lamp lights up in yellow. A relevant
warning is also displayed on the instrument
cluster display.
●
There is a fault in the sensors. Check the cau-
ses and solutions described in the information
about the ACC ›››page205 or the Lane Assist
›››page212.
●
There is a fault or a defect. Switch the engine
o and on again.
●
The system limits are exceeded.
●
If the problem persists, consult a specialised
workshop. SEAT recommends visiting a SEAT
dealership.
Grip the steering wheel
The warning lamp lights up white and a mes-
sage is then shown on the instrument cluster
display.
●
You released the steering wheel for a few sec-
onds. Take hold of the steering wheel and take
control of the vehicle.