Seat LEON 2024 - Page 302

300
Storing objects
NOTICE
Incorrect handling of the partition net could
cause damage.
●
Do not release the partition net when low-
ering it, as the net and other vehicle parts
could be damaged. Roll down the partition
net by hand.
Partition net with the rear seat backs
folded down.
✓ Valid for: LEON Sportstourer
Fig.189 Assembling the partition net in the
rear seat backrests.
Fig.190 In the luggage compartment:
partition net hooked into the rear seat
backrests.
Fitting the partition net
●
Fold the rear seat backrests forward.
●
Remove the partition net from the side sup-
ports.
●
Place the net casing in the rail slots in the
direction of the arrows ›››Fig.189
1
.
●
Push the casing towards the left side of the
vehicle in the direction of the arrow ›››Fig.189
2
and as far as it will go.
●
Check that the net is secure.
Pulling out and securing the partition net
●
Pull up handle ›››Fig.190
2
to remove the
net from the casing
4
.
●
Hook in the partition net on the right or left
side ›››Fig.190
3
(magnified image).
●
Hook in the partition net into the housing on
the other side ›››Fig.190
1
by pulling the rod.
The partition net is properly assembled when
the T-shaped ends are firmly secured in the
corresponding housings ›››Fig.190
3
and
1
.
Retracting the partition net
●
Remove the rod from the housings in the trims
of the roof side members.
●
Roll up the net into the casing ›››Fig.190
4
lowering it with your hand.
Removing the partition net
●
Pull the net casing out approximately 5 cm in
the opposite direction to the arrow ›››Fig.189
2
.
●
Remove the casing from the rails by pulling in
the opposite direction to the arrows ›››Fig.189
1
.
●
Lift the rear seat backrests.