WARNING
The high voltages in the electrical system
can give serious electrical shocks, causing
burns and even death!
●
Never touch the electrical wiring of the ig-
nition system.
●
Take care not to cause short circuits in the
electrical system.
WARNING
Using unsuitable fuses, repairing fuses or fit-
ting jumpers on a live circuit without fuses
can cause a fire and serious injury.
●
Never use a fuse with a higher value. Only
replace fuses with a fuse of the same amper-
age (same colour and markings) and size.
●
Never replace a fuse with a metal strip, sta-
ple or similar.
NOTICE
●
To prevent damage to the vehicle’s electri-
cal system, before replacing a fuse always
turn o the ignition, the lights and all electri-
cal components.
●
Protect the fuse boxes when open to pre-
vent the entry of dust or humidity as they can
damage the electrical system.
Note
In the vehicle, there are more fuses than
those indicated in this chapter. These should
only be replaced by a specialist workshop.
Fuses inside the vehicle
Fig.220 On the dashboard on the driver side:
lid of the fuse box.
Opening and closing the fuse box located
below the instrument panel
●
Open: fold the cover down ›››Fig.220.
●
Close: push back the cover it in until it clicks
into place.
Identifying fuses below the dashboard by
colours
Colour
Current intensity in
amps
Light brown 5
Brown 7.5
Red 10
Blue 15
Yellow 20
White or transparent 25
Green 30
Orange 40
Red 50
NOTICE
●
Always carefully remove the fuse box cov-
ers and refit them correctly to avoid prob-
lems with your vehicle.
●
Protect the fuse boxes when open to avoid
the entry of dust or humidity. Dirt and humid-
ity inside fuse boxes can cause damage to
the electrical system.
To Next Page
Loading...
