Operation
Closing the sunroof:
●
Automatic movement: slide your finger for-
ward over the functional area
A
.
●
Manual movement: slide forward over the
functional area
and keep it there.
Raising the sunroof:
●
The sunroof can only be raised if it is
closed.
●
Automatic movement: press briefly in the
centre of the functional area
B
Closing the sunroof when raised:
●
Automatic movement: slide your finger for-
ward over the functional area
A
or press
briefly in the centre of the functional area
B
.
Stop the automatic opening or closing move-
ment:
●
Press again on the functional area
.
Convenience function to open or
close the sunroof*
Fig. 100
Door handle: sensor surface.
The sunroof can be opened and closed with
the convenience function, just like the win-
dows.
Using the door lock*
●
Hold the key in the door lock of the driver
door in either the unlocking or locking posi-
tion to open or close the roof in the tilted po-
sition. Release the key to interrupt this func-
tion.
Using the remote control
●
Keep the locking or unlocking button press-
ed to open or close the roof. If you release the
button is the opening or closing will stop.
Using the Keyless Access* system (only
closing)
●
Press and hold the locking sensor surface
›››
Fig. 100 (arrow) on the door handle to
close the sunroof. If you release the sensor
surface, the closing movement stops.
Anti-trap function of the panoramic
sunroof and sunshade
The anti-trap function can reduce the risk of
injury when closing the sunroof and the sun
blind
›››
. If the sunroof or sun blind encoun-
ter resistance or an obstacle when closing,
they reopen immediately.
●
Check why the sunroof or sun blind do not
close.
●
Try to close the sunroof or sun blind again.
●
If the sunroof or sun blind cannot be closed
due to an obstacle or some resistance, it
stops at the corresponding position and then
opens. For automatic closing, a new closing
attempt might take place.
●
If the sunroof or sun blind is still unable to
close, close it without the anti-trap function.
116