49Cockpit
Calling up options
● Switch the ignition on.
● If a message or vehicle symbol is displayed, press
OK/RESET
(⇒ Fig. 29
A
).
● Press the top or bottom part of the rocker switch
B
until the desired op-
tion appears.
Multifunction display (MFI)
The multifunction display (MFI) has two automatic memories: 1 - Partial
memory and 2 - Total memory. The selected memory will be shown in the
lower right-hand corner of the display.
With the ignition switched on, and memory 1 or 2 displayed, briefly press
OK
to change from one memory to another.
1
Trip memo-
ry (for a
single jour-
ney).
The memory stores the values for the journey and the con-
sumption from the moment the ignition is switched on un-
til it is switched off again.
If the journey is broken for more than 2 hours, the memory
is automatically erased. If the journey is continued in less
than 2 hours after the ignition is switched off, the new da-
ta is added to the data already stored in the memory.
2
Total mem-
ory (for all
journeys).
The memory stores the values of any number of journeys,
until it counts a total of 19 hours and 59 minutes of driv-
ing, or 1999.9 km or miles of driving, depending on the
type of instrument panel fitted. On reaching either of these
limits, the memory is automatically erased and starts to
count from 0 again.
Possible displays
Menu Function
Time Current time in hours (h) and minutes (min).
Journey duration This indicates the hours (h) and minutes (min)
since the ignition was switched on.
Current fuel consump-
tion
The current fuel consumption display operates
throughout the journey, in litres/100 km; and with
the engine running and the vehicle stopped, in li-
tres/hour.
Average fuel consump-
tion
After turning on the ignition, average fuel con-
sumption in litres/100 km will be shown after trav-
elling about 100 metres. Otherwise horizontal lines
are displayed. The value shown is updated approxi-
mately every 5 seconds.
Operating range Approximate distance in km that can still be travel-
led with the fuel remaining in the tank, assuming
the same style of driving is maintained. This is cal-
culated using the current fuel consumption.
Distance covered Distance travelled, after ignition is switched on, in
km.
Average speed The average speed will be shown after a distance of
about 100 metres has been travelled. Otherwise
horizontal lines are displayed. The value shown is
updated approximately every 5 seconds.
Digital display of
speed
Current speed displayed digitally.
Liquid coolant temper-
ature digital display
Digital display of the current temperature of the en-
gine liquid coolant.
Warning at --- km/h If the stored speed is exceeded (between 30 -
250 km/h, or 18 - 155 mph), an audible warning is
given together with a visual warning.
Changing between display modes
● Press the rocker switch in the windscreen wiper lever.
Safety Operation Advice Technical specifications
To Next Page
Loading...
