Need help?Do you have a question about the Seat New Leon Cupra 2008 and is the answer not in the manual?
General| Brand | Seat |
|---|---|
| Model | New Leon Cupra 2008 |
| Category | Automobile |
| Language | English |
Table detailing front and rear track, camber, toe, ride height, etc.
Tightening torques based on ISO profiles for different bolt grades and sizes.
Specific torque values for common fixings like wheel nuts and drive shafts.
Requirements for the driver's seat and mounting brackets.
Base setup specifications for Toe, Camber, Roll Bars, Dampers, Springs, and Wing.
Location and fitment of SEAT Sport UK confirmation seals on the engine.
Prohibited engine modifications, including exhaust ports and manifolds.
Correct engine oil level procedures and dipstick markings.
Engine oil type, manufacture, replacement, and additive rules.
Correct procedure for engine start-up and shut down.
Description of the front upright's construction and ambidextrous design.
Information on rear lateral links and camber/toe adjustments.
Information on the front damper top mount and clearance.
Permitted front and rear spring options and combinations.
Dimensions and part numbers for front anti-roll bars.
Measurement and definition of minimum ride height.
Description of Tiptronic mode engagement and manual gear changes.
Procedure for using the launch control feature for standing starts.
Competitor responsibility for wheel speed sensors and their function.
Procedure for adjusting brake bias and pushrod length.
Minimum cold and recommended hot tyre pressures.
To Next Page
