Seat Toledo 2015 - Verification of Correct Placement

Towing bracket device
Fig. 103 Placing the key slot cover.
–
Remove the cap from the clamping bush
4
››› Fig. 99
by pulling downwards.
–
Pl
ac
e the ball-headed bar in the service po-
sition ››› page 117.
–
Hold the ball-headed bar from underneath
››› Fig. 102 and push it into the clamping
bush as far as possible until you hear it
click into place ›››
.
The manual regulator
A
automatically turns
in the op
po
site direction, adjusting to the
ball-headed bar ›››
.
–
Switch off the manual regulator lock with
key
B
by turning the key fully to the right
in the direction of arrow
1
– the arrow in
the key displays the “locked” symbol.
–
Remove the key in the direction of arrow
2
.
–
Place cover
C
over the manual regulator
lock in the direction of arrow
3
››› Fig. 103
.
–
V
erif
y the correct placement of the ball-
headed bar ››› page 119.
WARNING
●
Do not hold the manual regulator with your
hand when fitting the ball-headed bar since
you could sustain injuries to your fingers.
●
When mounting the ball-headed bar, al-
ways lock it with a key and remove the key
from the slot.
●
The ball-headed bar must not be in the
service position with the key in the key slot.
●
If the ball-headed bar is not placed in the
service position you will not be able to place
it in the clamping bush.
CAUTION
When removing the key, always place the
cover over the key slot of the manual regula-
tor to prevent dirt from entering.
Note
Once removed, place the clamping bush cap
in an appropriate location in the boot.
Verification of correct placement
Fig. 104 Correct placement of the ball-head-
ed bar.
Before using the ball-headed bar, ensure it is
correctly fitted.
Ensure that:
●
The ball-headed bar does not come out of
the clamping bush in a “jerky” manner.
●
The red mark
A
››› Fig. 104
on the manual
r
e
gulator signals toward the white mark on
the ball-headed bar.
●
The manual regulator is adjusted to the
ball-headed bar, leaving no space between
them.
●
The regulator is locked and the key has
been removed.
●
Cover
B
has been placed over the manual
regulator lock.
»
119
Technical specifications
AdviceOperationSafety