Seat Toledo 2015 - Changing Daytime Driving Light Bulbs; Changing Turn Signal Bulbs

Advice
Changing the dipped headlight bulb
Fig. 146 Changing dipped beam headlight
bulbs: wheel housing.
Fig. 147 Changing dipped beam headlight
bulbs.
–
Turn the wheel for access to the wheel
housing cover and remove the cover
››› Fig. 146
.
–
R
emo
ve the protective cover from the head-
light ››› Fig. 147.
–
Remove connector ››› Fig. 147
1
by pulling
outward.
–
Unclip the retainer spring ››› Fig. 147
2
pressing clockwise and inwards.
–
Extract the bulb and fit the replacement so
that the lug on the base fits into the recess
on the reflector.
–
Fit the connector.
–
Fit the protective cover. Make sure that the
cover fits correctly on the housing during
operation.
–
Replace the wheel housing cover.
–
Check whether the new bulb is working.
Changing turn signal bulbs
Fig. 148 Changing turn signal bulbs.
–
Raise the bonnet.
–
Turn the bulb holder ››› Fig. 148
1
anti-
clockwise and remove it.
–
Remove the bulb by pressing on the bulb
holder and turning it anti-clockwise at the
same time.
–
Fit the replacement bulb in the bulb holder
and turn clockwise as far as it will go.
–
Check whether the new bulb is working.
Changing daytime driving light bulbs
Fig. 149 Changing daytime driving light
bulbs.
–
Raise the bonnet.
–
Turn the bulb holder ››› Fig. 149
1
anti-
clockwise and remove it.
–
Remove the bulb by pressing on the bulb
holder and turning it anti-clockwise at the
same time.
168