Fuses and bulbs
Fitting the rear light
Fig. 102 Fit the tail light unit.
Fig. 103 Fit the tail light unit.
–
Make sure the connector is correctly in
p
l
ac
e.
–
Press the rear light unit backwards (driving
direction) by fitting the fastenings into the
rubber mountings ››› Fig. 102
A
.
–
Take the screwdriver or a Torx 20 key (T20)
fr
om the
v
ehicle tool kit and tighten (turn-
ing clockwise ››› Fig. 103) the two retaining
screws that secure the front of the light.
Changing tail lights (on the
rear lid)
Removing the bulb holder
1)
Fig. 104 Remove the cover from the boot lid.
Fig. 105 Remove the bulb holder.
The rear lid must be open to change the
b
u
l
bs.
You can access the bulb holder for the inner
tail lights through the inside of the rear lid.
–
Check which of the bulbs is defective.
»
1)
For rear-lid LED rear lights, only the reverse and
retro f
og bulb can be replaced. The illustrations in
the manual correspond to the bulb version and do
not correspond exactly to the LED version.
89
Technical dataAdviceOperationEmergenciesSafety
To Next Page
Loading...
