Connectivity
Activation of Full Link
Fig. 17 Full Link Setup
Fig. 18
Full Link menu
Data connection via Wi-Fi or SIM is not nec-
essary to establish the connection between
the smartphone and Full Link.
Data connection via Wi-Fi or SIM is necessary
to enable all of the app features
1)
.
Proceed as follows to use Full Link:
●
Switch on the Infotainment system
●
Connect the smartphone to the vehicle's
USB port using a USB cable ››› Booklet In-
struction manual.
●
In the main menu for the Full Link setup,
select Activate data transfer for SEAT apps
›››
Fig. 17:
Finally, a message will appear stating that
data transfer will commence when the device
is connected. Please note that data is trans-
ferred over connections between your vehicle
and mobile device. Press OK. Once selected,
the technology compatible with your device
can be used.
Note
Depending on your smartphone, it may have
to be unlocked for the connection to occur.
What should I do if it does not con-
nect?
Restart the mobile device
Check the USB cable visually.
Make sure that the USB cable is not damaged. Check
that both connections (USB/micro USB) are not dam-
aged or worn.
Visually check that
the USB ports are
properly connected.
Check that the vehi-
cle and device USB
connections are not
damaged and/or
worn.
Clean the USB ports (device and
vehicle).
Try another compatible mobile
device.
Have the USB port replaced at a
SEAT Authorised Service.
Have the mobile device re-
paired or replace it.
Try another compatible mobile device.
1)
Using the data connection to transfer the smart-
phone apps to Full Link may involve additional
charges. Please check the charges with your opera-
tor.
21
To Next Page
Loading...
