2.78
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– CLIMATE CONTROL
HANDLING INSTRUCTIONS
The air conditioner is a combined cooling
and heating system which provides the
maximum possible comfort all the year
round.
The cooling system only works when the
engine is running, the ambient tempera-
ture is above about +5°C and the ventila-
tor is set to positions
I
to
IIII
.
When the cooling system is switched on it
reduces not only the temperature inside
the vehicle but also the air humidity mak-
ing the vehicle occupants feel more com-
fortable, when there is a high level of
humidity.
Control eelements
A –– TTemperature sselector
To tthe rright
– increases heat output
To tthe lleft
– decreases heat output
If the air conditioning is connected the
cooling capacity is increased if you turn
the regulator to the right.
B –– BBlower
Air throughput can be adjusted in four
stages.
In position 0 the blower is switched off,
but air is let in from the outside. If you
want to stop polluted (smelly) air coming
in from outside press switch
E
(air circula-
tion).
Warning
As tthis mmay mmake tthe wwindows
steam uup yyou sshould nnot ddrive ffor
too llong iin tthis pposition.
C –– AAir ddistribution
Air fflow ffor
footwell
Vents
5
are opened.
All vents
3
and
4
must be opened to
direct all the air flow to the feet.
Air fflow ffor tthe
windscreen aarea
Vents
3
can be used to direct air to the
side windows.
Vents
1
and
2
are opened.
Air fflow oof
the vvents
Vents
1
,
2
and
5
are closed. The air comes
out of vents
3
and
4
.
In the positions mentioned above there is
always a leak of air to the remaining
vents.
TO2-002
To Next Page
Loading...
