maximum of two hours sitting is recommended at any one time. You must also
observe Patient specific recommendations and guidelines as set by their health
professional with regard to pressure care.
• For the safety of the User and Patient and to ensure longevity of the electronics
on the powered options, please ensure that your MONACO ASSIST™ is charged
daily using a Seating Matters charger through the handset of the chair. For further
details or replacement chargers please contact your Seating Matters provider.
• The chair should not be transported in a vehicle while the Patient is seated on the
chair.
• When operating the leg rest, recline and tilt in space features on the chair please
ensure there is a 450mm gap at the front and back of the chair to prevent the back or
leg rest coming into contact with a wall or any other object.
Assembly and installation instructions
• This chair should arrive fully assembled. The User must ensure that the product is
in good condition before use (check all nuts and bolts are fastened, fabric in good
condition etc.). If there are any problems, these must be reported to your Seating
Matters provider and corrected before the chair is put into use.
• The product must be used on a level, plane, hard surface with the brakes engaged to
avoid it moving during use and to ensure stability.
• The product must be clear of any obstacles before reclining the back to avoid damage
to the chair and objects in its immediate environment.
• The product may not be left in an outdoor environment. More information on fabrics
and their properties can be found on page 12.
To Next Page
Loading...