32
No. Alarm signal Red LED Explanation Solution
During programming
7 No signal Flashes approx. once every
second
The detector is in programming mode. The button has
been pressed and held down for approx. 2-3 seconds.
The device will automatically revert to standard mode
after approx. 1 minute
8 No signal Lights up for approx. 4-5
seconds
Programming has been successfuly completed. Press and hold down the button for a minimum of
approx. 5 seconds to restore factory settings.
9 A short beep is emitted
when the button is
released
Flashes approx. every 0.5
seconds
The detector has been reset to the factory settings.
The button has been pressed and held down for a
minimum of approx. 5 seconds.
Once the button is released, the detector reverts to
standard mode without radio communication
Table of functions
To Next Page
Loading...