Secure Liberty 100 - Page 59

BGX501-767-R02
Liberty 100 Smart Electricity Meter Technical Reference Manual
Page 59 of 116
Error! Not a valid result for
table.Manual Display in Credit
Key 4: Historical monthly consumption data
A short press of key ‘4’ will initiate the associated display sequence. After each set of information comprising a
title followed by its data, either a four (4) seconds wait or short press of the key will advance the display to the
next set of information as described below.
The display will sroll forward through tweleve (12) months historical consumption data starting with the last
month which is the same as the ‘LAST MONTH’ in the above Key 3 sequence. For example, if the current
month is ‘August’ the last month will be ‘July’ so the data sequence will begin from ‘July’ and end with ‘August’.
Title 1: Historical monthly consumption data
(timeout 2 secs)
Press key 4 to advance to the next display
The 1
st
display associated with key 4 indicating that
the key is assigned to display historical monthly
consumption for the past twelve (12) months.
Title 2: Last month’s consumption and its cost
(timeout 2 secs)
Followed by value
(timeout 4 secs)
Followed by value
(timeout 4 secs)
Press key 4 to advance to the next display
The 2
nd
set displays consumption data for the last
month.
The example shows that 15.6 kWh was used last
month and its associated cost was £11.78.
… … … … … … … … … … … … …
… … … … … … … … … … … … …
… … … … … … … … … … … … …
Press key 4 to advance to the next display
The displays will continue to cycle through each
previous month’s consumption data.
Title 3: Consumption and cost in ‘August’
(timeout 2 secs)
Followed by value
(timeout 4 secs)
The last display in the sequence indicating
consumption data in the month of ‘August’.
The example shows that 15.6 kWh was used in the
month and its associated cost is £11.78.