BGX701-240-R01 Liberty gas EG4v12 user cum maintenance manual Page 21 of 32
● ‘Low emergency credit’ alert if an emergency credit level in the meter reaches or passes below the
configured low emergency credit threshold.
● ‘Emergency credit exhausted’ alert if there is no emergency credit left in the meter
5.9 Meter valve state
The supply valve has three states –
1. On: Valve will be in the opened state, and there will be continuity of supply
2. Off: Valve will be in a closed state, and there will be no supply
3. READY: For safety reasons, a ‘READY’ state is introduced between the supply OFF and ON states. This
gives the user the control to reconnect their supply from the meter when it is safe to do so (e.g.
appliances are off). When the gas valve is in ‘READY’ state, the ‘READY’ icon will illuminate on the LCD,
and an appropriate message will be displayed indicating that the meter is ready to reconnect supply and
is waiting for the user to press the correct key sequence on the meter’s keypad.
Important!
The supply will get disconnected in case of the following conditions:
● No balance
● Excessive gas flow (Inrush flow)- During the valve opening process (When user manually presses ‘A’
followed by ‘B’) if gas flow exceeds the uncontrolled gas flow rate (30 litres/hour), it returns back to
the ‘READY’ state.
● Tamper
Reconnection of the valve will always require manual intervention. Fix the reason for valve
disconnection, then press Key A, followed by Key B.
5.9.1 Opening the valve from the ‘READY ‘state
When the valve is in ‘READY’ state, the ‘READY’ icon will illuminate on the meter’s LCD followed by the
messages ‘PRESS A’ and ‘CONNECT’. Pressing key ‘A’ on the meter displays ‘PRESS B’ followed by ‘CONFIRM’.
Pressing key ‘B’ within 30 seconds of pressing key ‘A’ opens the valve and resumes the supply. Otherwise, it
stays in the ‘READY’ state, and the meter’s display reverts to ‘PRESS A’ followed by and ‘CONNECT’ display
sequence.
5.9.2 Gas valve connection displays
1. READY state display cycle
When the meter’s valve is in READY state, the following display sequence will be shown for the user to
connect their supply.
Followed by
Acknowledge the above message by pressing key ‘A’ within 10 seconds. Otherwise, the display goes into
sleep mode and will return by pressing any key on the meter’s keypad.
2. Confirmation display cycle
After pressing key ‘A’, the following confirmation display cycle will be shown for 30 seconds:
To Next Page
Loading...
