THIS HEATER IS TO BE INSTALLED BY AN AUTHORISED PERSON ONLY
DO NOT Operate this appliance before reading the instruction booklet.
DO NOT Place articles on or against this appliance.
DO NOT Use or store flammable materials near this appliance.
DO NOT Operate this appliance with panels, covers or guards removed.
This Braemar gas ducted heater must be installed in accordance with these instructions, local
gas fitting regulations, municipal building codes, electrical wiring regulations, Australian
Standard AS/NZS 5601 Gas Installations and any other relevant statutory requirements.
This heater must not be installed downstream from an evaporative cooler, air washer or
indoor unit of a refrigerated system. This heater is not suitable for installation in a marine
environment.
For external installations, ensure that the heater is located to maintain the minimum flue
clearances as specified below and in AS/NZS 5601. Measurement is taken from the edges of
the flue terminal.
GAS TYPE: Refer label alongside gas inlet.
GAS CONSUMPTION: Refer data label on underside of appliance lid.
TH3/TH4/TH5 SERIES - Configured for
EXTERNAL, INTERNAL or UNDER
FLOOR INSTALLATION
(with correct flue system)
TH3/TH4/TH5 SERIES - Configured for
INTERNAL or UNDER FLOOR
INSTALLATION
(with correct flue system)
Heaters
supplied in this
configuration
ex-factory.
Heaters can be
converted to this
configuration
on-site.
BRAEMAR ECOSTAR GAS DUCTED HEATERS
INSTALLATION MANUAL TH3-TH4-TH5
MODELS COVERED BY THIS MANUAL:
zTH3 series - 3.7 stars
zTH4 series - 4.7 stars
zTH5 series - 5.6 stars
UNPACKING THE HEATER
Remove the plastic wrap and cardboard transport cover. Check that the heater model and
gas type is as required - model details are provided on the specification label on the end
panel of the heater, gas type is given on the label next to the gas inlet. Report any transit
damage within 7 days - Do not install the heater if it is damaged.
SEPTEMBER 2011
Manual Part No: 623467r
To Next Page
Need help?
General