G eneral o peratio n
Select the source by setting the FUNC TIO N S ELEC TO R to C D, TA PE(O FF)or RA DIO .
Set the desired volume level using the V O LUME K NO B.
To turn off the unit, set the FUNC TIO N S ELEC TO R to O FF.
Radio
To listen to the FM radio, extend the telescopic antenna and adjust it for optimum reception. Reduce the
length of the a ntenna if the signal is too strong (if you are v ery n ear the transmitter, for example).
As the unit is equipped with a b uilt-in antenna, the telescopic antenna is not needed to listen to AM stations.
Move the e ntire unit to adjust the built-in antenna for optimum reception.
Radio rec eptio n
Set the FUNC TIO N S ELEC TO R on RA DIO .
Position the BA ND S ELE C TO R on the desired band: AM, FM o r FM S T.
Turn the TUNING K NO B to search for the desired station.
NOTE:
The FM stereo indicator comes on if the BA ND S ELEC TO R is set on FM S T. and you have tuned the radio to
an FM stereo station.
When you have finished listening to the radio, position the FUNC TIO N S ELEC TO R to O FF.
Play ing a c assette
Set the FUNC TIO N S ELEC TO R on TA PE.
Press STO P/EJEC T to open the c assette door.
Insert a recorded cassette and close the c assette door.
Press PLAY to start playback.
To interrupt playback, press PA US E . To resume, press the key a gain.
By p ressing the FWD or R EW button, fast winding of the tape is possible in both directions.
To stop the tape, press STO P/EJEC T button.
Stereo h eadphones jack
C onnect headphones with the volume set low and increase it if required. Prolonged listening through some
headphones a t high volume settings can result in hearing damage.
Reduce the V O LUME to a low level before putting on the headphones. You can then adjust the V O LUME
progressively to a c omfortable level.
G eneral O peration
To Next Page
Loading...
General