11
CONTROL STICK
110
11-5 GUIDE PLATE REPLACEMENT
Among the potential causes of abnormal control stick operability, apart from volume malfunctions, are wear and/or
damage to guide plates.
Use the following tools to replace a guide plate.
- 2.5 mm Allen wrench or screwdriver
- 4 mm Allen wrench or screwdriver
1
Cut off the power and open the controller lid at the bottom of the control stick. (See 11-1.)
2
Take out 4 hexagon socket screws that hold down the guide plate, then replace the guide plate.
FIG. 11-5
To Next Page
Loading...
