14
COIN SELECTOR
128
4
Remove and clean smears by using a soft cloth dipped in water or diluted chemical detergent and then
squeezed dry.
5
Remove the CRADLE.
When removing the retaining ring (E ring), be very careful so as not to bend the rotary shaft.
FIG. 14b
6
Remove stain from the rotary shaft and shaft receiving portions by wiping off with a soft cloth, etc.
7
After wiping off as per 6 above, further apply a dry cloth, etc. to cause the Coin Selector to dry completely.
Coin Insertion Test
Once every month, when performing the Coin SW Test, simultaneously check the following:
Does the Coin Meter count satisfactorily?
Does the coin drop into the cashbox correctly?
Is the coin rejected when inserted while keeping the REJECT Button pressed down?
FIG. 14c
To Next Page
Loading...
