Sega AFTER BURNER CLIMAX - Operation Area Requirements

2
PRECAUTIONS REGARDING INSTALLATION LOCATION
6
2-2 OPERATION AREA
Electricity Consumption:
MAX. 6.30 A (AC 120 V, 60 Hz)
• For the operation of this machine, secure a minimum area of 2.1 m (W) x 2.18
m (D). The dimensions of the base periphery are established in consideration of
ventilation, maintenance and customer passage. With this product there is the
danger that someone could fall down while getting onto the base or the seat.
And if they fall and hit their head, there could be a very serious injury. Be sure to
always secure enough space as prescribed in this manual.
• Besuretoprovidesufcientspacespeciedinthismanual.Donotallowobjects
toblocktheventilationports.Itcancausegenerationofheatandare.
• SEGA shall not be held responsible for damage or compensation for damage to
a third party, resulting from the failure to observe this instruction.
• Ifthemachinedoesnottthroughtheentrywaytotheinstallationlocation,do
notdisassembleitwithoutrstconsultingtheinstructions.Themachineshould
only be disassembled in accordance with the instructions listed in this manual;
donotattempttodisassembleitinanyotherway.Specictoolsandadjustment
procedures are required to assemble and disassemble the mechanical parts.
Attempting to assemble or disassemble the machine without consulting the
instructionsmayresultinaccidentsduringassembly/disassemblyandelectric
shock,shortcircuits,and/orpersonalinjuryduringoperation.Ifthemachinestill
doesnottthroughtheentrywayafterfollowingtheproceduresinthismanual,
contactyourretailerortheofcelistedinthismanual.
• If the machine is still too large to fit through the entryway after following the
procedures listed in this manual, do not tip the machine on its side. Attempting
to transport the machine while it is tipped on its side may cause accidents. It
may also damage or warp parts of the machine, resulting in accidents during
operation.
• To install this product, the entrance must be at least 1.3 m in width and 1.95 m in
height. If the entrance is too narrow, do not tilt the product carelessly. If all the
product weight is put on the casters at one side only, there could be damages
or deformations, causing serious accidents such as workers getting caught
underneath.