17
TROUBLESHOOTING
138
[DISPLAY] Error ABX01 MOTOR DRIVE COMMUNICATION ERROR
[CAUSE] A motor drive communication error.
[COUNTERMEASURES] Failure to communicate with the control board for seat movement. Check the
cable connecting them.
[DISPLAY] Error ABX02 MOTOR DRIVE OVERHEATING/OVERLOAD ERROR
[CAUSE] A motor drive overheating/overload error.
[COUNTERMEASURES] The seat movement motor thermal element has been activated. Wait for it to cool
down and then restart.
[DISPLAY] Error ABX03 MOTOR DRIVE ENCODER ERROR
[CAUSE] A motor drive encoder error.
[COUNTERMEASURES] Irregular encoder data for seat movement. Check that there are no irregularities
with the cable to the encoder.
[DISPLAY] Error ABX04 MOTOR DRIVE OVERCURRENT ERROR
[CAUSE] A motor drive over current error.
[COUNTERMEASURES] Too much current owed into the seat movement motor. Check that there are no
problems with the cable to the motor.
[DISPLAY] Error ABX05 THE SENSOR REACTED. PLEASE REMOVE THE
OBSTACLES, AND RESTART.
[CAUSE] A sensor reacted during cabinet initialization.
[COUNTERMEASURES] A sensor reacted during initialization. Remove the obstacle and restart the
cabinet.
[DISPLAY] Error ABX06 INITIALIZING ERROR
[CAUSE] An error occurred during cabinet initialization.
[COUNTERMEASURES] An error occurred during initialization. Check that nothing could be blocking the
movement of the seat and restart the cabinet.
[DISPLAY] Error ABX07 CONNECTION TIMEOUT
[CAUSE] Timed-out connecting to the network.
[COUNTERMEASURES] Failed to connect to the network. Check that the network cable is connected
properly. Conrm that the LINK NUM setting is not set to “1”.
[DISPLAY] Error ABX08 LINK ID ERROR
[CAUSE] LINK ID is not set correctly. LINK ID is set to the same number.
[COUNTERMEASURES] An error occurred when trying to connect to the network. Set the LINK ID of 2
game units to different numbers.
To Next Page
Loading...
