Sega Dinosaur King - Assembling the Pop

−  − −  −
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
−  − −  −
󰴥 Connect one end of the earth wire to the
AC Unit earth terminal, and the other
end to the indoor earth terminal. The AC
Unit earth terminal has a Bolt and Nut
combination. Take off the Nut, pass the
earth wire through the Bolt, and fasten
the nut. <For Taiwan>
* Note that the earth wire is incorporated
in the power cord for the Areas of AC
120V (USA) and AC 220 ~ 240V, and
therefore, this procedure is not necessary.
󰴦 Firmly insert the power plug into the
socket outlet. Insert the opposite side
of the power cord plug to the AC Unit's
connector ("INLET").
󰴧 Perform wiring for the power cord and
earth wire. Install protective insulation
for the power cord and earth wire.
Connect the earth wire to
the earth terminal.
FIG. 6.2b *Earth Wire Connection
FIG. 6.2c Connecting the Power Cord and Earth Wire
WIRINGCOVER
󰴤 Remove the separation paper of the
double-sided tape on the POP B back
side, and attach to the POP A rmly.
󰴥 Remove the 3 truss screws (M412)
from the cabinet, replacing them with the
3 supplied truss screws (M414), and
fasten the POP as shown in the gure on
the right.
The POP support board for this machine
is packed in air-wrap and secured to the
front of the monitor cover.
TRUSSSCREW(3),chrome
M414
POPSUPPORT
BOARD
POPA
POPB
󱦳
ASSEMBLING THE POP
FIG. 6.3a
FIG. 6.3b