Sega Dinosaur King - Powering on

−  − −  −
−  − −  −
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
MANAGEMENTCHIPREADER/WRITER
MANAGEMENTCHIP
While consulting section 7, “MANAGEMENT
CHIP AND DINOSAUR KING CARDS”,
insert the Management Chip into the
Management Chip reader/writer, and load the
cards into the card dispenser.
󱦵
INSERTING THE MANAGEMENT CHIP AND DINOSAUR KING CARDS
Turning on the AC unit main switch and the maintenance switch will power on the machine. When
powering on the machine, the system start-up screen will be displayed, and an advertisement
screen will be shown afterwards. On this machine, the number of credits will be saved even after
shutting off the power. If credits allowing further play remain in the machine when powered off, a
card will be dispensed and a game will begin when the machine is restarted.
 In the event that there are no cards loaded into the card dispenser, a CARD ERROR message
screen will be displayed. In such a case, turn off the machine, load cards, and turn it on again.
 In the maintenance switch section of the service door, use the audio volume adjuster to regulate
the volume. Also, the choice of whether or not to play sound during the advertisement screen
can be selected in the TEST MODE settings.
󱦷
POWERING ON
This machine cannot be powered on unless both the AC unit on the back of the
cabinet and the power switch in the maintenance switch section on the inside of
the service door are both turned on.
STOP
IMPORTANT
PHOTO. 6.4
POWERSWITCH
TESTBUTTON
MAINTENANCESWITCHSECTION
CARDDISPENSER
PHOTO. 6.5