Sega Dinosaur King - MANAGEMENT CHIP AND DINOSAUR KING CARDS; INSTALLING MANAGEMENT CHIP

−  − −  −
−  − −  −
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
Do not perform any of the following actions to avoid damaging the machine.
● Removing the Management Chip or turning the power on/off when the red
Management Chip reader/writer "BUSY" lamp is ashing.
● Removing/inserting Management Chips while a game is in progress.
● Inserting Management Chips/Cards designed for other machines or game
versions.
● Loading more than the maximum number of cards (600). Doing so can result in
card jamming or faulty dispensing.
● Turn off the power prior to using the card dispenser.
● Do not load used cards as they may jam or cause damage to the equipment.
When the credits reach zero and the warning screen is displayed, install a new Management Chip.
A Management Chip that causes the “EMPTY LAMP” to light up cannot be used.
There are two reader/writer units. If the chip is recognized by either one of them, the game can be
operated.
The status of the chip can be veried in Test Mode.
7. MANAGEMENT CHIP AND DINOSAUR KING CARDS
WARNING
！
STOP
IMPORTANT
7−1 INSTALLING MANAGEMENT CHIP
󰴤 Turn off the power switch inside the
door.
󰴥 Loosen the screw locking the
Management Chip holder.
󰴦 Insert the Management Chip rmly into
the Management Chip reader/writer slot.
󰴧 Turn on the power switch inside the
door.
󰴨 If the EMPTY LAMP lights up, there
may be a malfunction. Check that the
chip is correctly inserted.
MANAGEMENTCHIPHOLDER
The Management Chip is supplied with the card set for use with this machine.
Notes：
・ Be sure to turn the power off and on again when inserting/removing Management Chips, even if
the machine is in use.
・ The counter in the Management Chip is set for the number of cards in one carton, and each
dispensed card reduces the counter number by . One Management Chip allows game operation
for one carton of cards.
PHOTO 7.1