Sega Dinosaur King - MANAGEMENT CHIP ERROR CODES

−  − −  −
−  − −  −
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
ERROR 100: Management Chip, reader/writer error
[DISPLAY] ERROR 100
RFID READER NOT READY
(If the error occurs in Test Mode, “READER NOT READY” is displayed)
[CAUSE] The wire connection is not properly congured, or there may be a broken wire or
damaged hardware.
[COUNTERMEASURES] Turn off the power, check the wire connection, and then restart the
machine. If the problem still persists, the machine may be damaged.
Replace broken parts with new ones.
ERROR 101: Management Chip read error
[DISPLAY] ERROR 101
RFID READ ERROR
(If the error occurs in Test Mode, “READ ERROR” is displayed)
[CAUSE] (1) The wire connection is not congured properly, or there may be a broken wire
or damaged hardware.
(2) The Management Chip is not inserted properly in the slot.
[COUNTERMEASURES] (1) Turn off the power, check the wire connection, and then restart
the machine. If the problem still persists, the machine may be
damaged. Replace broken parts with new ones.
(2) Check the status of the Management Chip and reinsert it. The
chip may be damaged. Replace it with a new one if necessary.
ERROR 102: Management Chip write error
[DISPLAY] ERROR 102
RFID WRITE ERROR
[CAUSE] The process of writing data to the Management Chip does not complete properly.
The veried data does not match the results of the data check. The Management
Chip is not inserted properly in the slot.
[COUNTERMEASURES] Reinsert the Management Chip properly. If the problem still persists,
the chip may be damaged. Replace it with a new one.
ERROR 103: Management Chip decrement error
[DISPLAY] ERROR 103
RFID DECREMENT ERROR
[CAUSE] The process of credit reduction does not complete properly. The counter does not
decrease by 1 after the reduction process. The Management Chip is not inserted
properly in the slot.
[COUNTERMEASURES] Reinsert the Management Chip properly. If the problem still persists,
the chip may be damaged. Replace it with a new one.
7−2 MANAGEMENT CHIP ERROR CODES
When problems occur with the Management Chip, the following error codes will be displayed
on the screen. Refer to the “cause” and “countermeasures” list below in order to deal with the
problem appropriately.
The following error codes will not be displayed if either the Management Chip or the reader/writer
is functioning properly.