Sega Dinosaur King - REMOVING THE LITHUM BATTERY

−  − −  −
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
−  − −  −
● When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
● Be careful not to damage wiring. Damaging wiring may cause electric shock or
short circuit.
● To prevent overheating, explosion, or re:
・ Do not recharge, disassemble, heat, incinerate, or short the battery.
・ Do not allow the battery to come into direct contact with metallic objects or
other batteries.
・ To preserve or to dispose of the battery, wrap it in tape or other insulating
material.
● Follow local regulations when disposing of the battery. Improper disposal can
damage the environment.
If this error appears within one year then it is a problem with the board itself. The
board must be replaced.
To avoid risk of malfunction and damage:
・ Make sure the positive and negative ends are aligned correctly.
・ Use only batteries approved for use with this unit.
WARNING
！
CAUTION
！
STOP
IMPORTANT
10−5 REMOVING THE LITHUM BATTERY
This operation must only be performed when the battery is dead or under other
special circumstances and never at any other time.
󰴤 Carefully remove the battery in the battery holder (BAT1) on the SystemSP board.
󰴥 Place the new battery (CR2032) into the holder with the + terminal facing upwards.
SystemSP Battery
 SEGA PART No.:
401-0054 or 401-0065
 SEGA PART NAME:
BATTERY CR2032/1F MATSUSHITA
or
BATTERY CR2032 HITACHIMAXELL
BATTERYCR2032
FIG. 10.5