4
Replace the Fluorescent Tube with a new one of the same type and re-assemble the Billboard in the reverse
order.
3
Locate the Fluorescent Lamp. Unclip the end caps from both ends of the lamp. Using both hands, carefully
pull the lamp directly towards you. Due to the possible risk of broken Glass during this procedure,
protective clothing, such as gloves and safety glasses should be worn
1
The Billboard Fluorescent Tube is located inside the Billboard directly behind the Billboard Plate, before
attempting to change the lamp, TURN THE POWER OFF.
2
To gain access to the Fluorescent Tube, extract the (6) xing screws which hold the Billboard Plate in place
and remove.
13-2 FLUORESCENT TUBES - BILLBOARD
THIS WORK ON TOP OF THE CABINET, SHOULD NOT BE UNDERTAKEN WITHOUT THE
USE OF A SUITABLE STEP OR FOOTSTOOL.
MAKE SURE THAT THE MAIN SUPPLY VOLTAGE TO THE MACHINE IS SWITCHED OFF
BEFORE ATTEMPTING TO CARRY OUT THIS WORK
(6) M4 internal Hex Bolt Chrome
(6) M4 Inset Washer
Billboard Plate
Fluorescent Lamp
To Next Page
Loading...
