1
Remove the 2 screws, and take off the lower
door.
2
Slide the LAN cable lid on the lower door towards the center and fasten it in place. (See 19-2.)
3
Connect the 5 m LAN cable to RINGWIDE inside the cabinet. (See 19-2.)
4
Temporarily fasten the opposite end of the 5 m
LAN cable connected to RINGWIDE to the
inside of the lower door using the cord clamp.
5
Use the cord clamp that fastens the wires in place inside the cabinet to fasten in place the part of the 5 m
LAN cable going from RINGWIDE to the lower door. This work is the same for the other cabinets. (See
19-2, Step 8.)
6
Connect the 3P connector of ASSY hub included with the kit to the 3P connector inside the cabinet.
This connector is for the power supply. Each of the cabinets is equipped for the ASSY hub.
SCREW (2), black
M4 x 30, w/at & spring washers, large at washer used
Connect the 3P connector.
To Next Page
Loading...
